Multi-Tech Systems CDMA Wireless Modem - Manual (Page 108)

Chapter 14 – Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 108
Request PRL Version Information +WPRL
Description: This command requests PRL Version information for the currently selected NAM.
Syntax: Command syntax: AT+WPRL?
Command Possible Responses
AT+WPRL?
Note: Request current NAM’s PRL version +WPRL: 1024
OK
AT+WPRL?
Note: Request current NAM’s PRL version +CME ERROR: 41
Note: PRL request invalid because there’s no PRL loaded.
Note: The range for PRL is a 16-bit type.
Minute Alert +WMBP
Description: This command is used to set the minute alert while in a voice conversation.
Values: <mode>
0: Disable alert
1: Enable alert
<interval>
1 – 30: Time in minutes
Syntax:
Command syntax: AT+WMBP=<mode>,<interval>
Command Possible Responses
AT+WMBP=0
Note: Turn off the alert OK
AT+WMBP=1,4
Note: Turn on the alert and set 4 minutes apart OK
AT+WMBP?
Note: Request current setting +WMBP: 1,4
Note: PRL request invalid because there’s no PRL
loaded.
AT+WMBP=?
Note: Display valid parameter ranges. +WMBP: (0-1),(1-30)