Multi-Tech Systems CDMA Wireless Modem - Manual (Page 126)

Chapter 16 – Provisioning AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 126
Access Overload Class +WAOC
Description: This command is used to set the Access Overload Class.
Values: <number>
Access overload value range – 0 to 15.
Syntax: Command syntax: AT+WAOC=<number>
Command Possible Responses
AT+WAOC?
Note: Get current Access Overload Class +WAOC: 5
OK
AT+WAOC=7
Note: Set Access Overload Class to 7 OK
Slot Cycle Index +WSCI
Description: This command is used to set the slot cycle index.
Values: <number>
Slot cycle index, ranges from 0 to 7.
Syntax: Command syntax: AT+WSCI=<number>
Command Possible Responses
AT+WSCI?
Note: Read the current slot cycle index +WSCI: 2
OK
AT+WSCI=1
Note: Set the slot cycle index OK
Primary Browser Gateway +WBGP
Description: This command is used to set the primary browser gateway IP address (Ipv4). If a browser is
not natively supported by the modem, this command will return ERROR.
Values: <num>
0-255
Syntax: Command syntax: AT+WBGP=<num>,<num>,<num>,<num>
Command Possible Responses
AT+WBGP?
Note: Get current gateway +WBGP: 127,0,0,1
OK
AT+WBGP=255,255,255,0
Note: Set primary gateway to 255.255.255.0 OK
Secondary Browser Gateway +WBGS
Description: This command is used to set the secondary browser gateway IP address (Ipv4). If a browser
is not natively supported by the modem, this command will return ERROR.
Values: <num>
0-255
Syntax: Command syntax: AT+WBGS=< num >,< num >,< num >,< num >
Command Possible Responses
AT+WBGS?
Note: Get current primary gateway +WBGS: 127,0,0,1
OK
AT+WBGS=255,21,255,0
Note: Set secondary gateway to 255.21.255.0 OK