Multi-Tech Systems CDMA Wireless Modem - Manual (Page 93)

Chapter 13 – Position Determination (GPS) AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 93
Set IP Address of gpsOne Session +WPDIP
Description: This command allows the user to set the IP address of the gpsOne session if the TCP/IP
transport layer is used.
Values:
<ip_address>
Specified in format xxx.xxx.xxx.xxx where xxx is 000 to 255.
Syntax:
Command syntax: AT+WPDIP=<ip_address>
Command Possible Responses
AT+WPDIP?
Note: Query current gpsOne IP. +WPDIP:192.168.135.124
OK
AT+WPDIP=192.168.135.124 OK
Note: New gpsOne IP set.
Set Port of gpsOne Session +WPDPT
Description: This command allows the user to set the port value for the gpsOne session if the TCP/IP
transport layer is used.
Values:
<port>
Value is carrier specific.
Syntax:
Command syntax: AT+WPDIP=<port>
Command Possible Responses
AT+WPDPT?
Note: Query current
gpsOne port value. +WPDPT: 4911
OK
AT+WPDPT=4911 OK
Note: New gpsOne port value set.