Multi-Tech Systems CDMA Wireless Modem - Manual (Page 194)

Chapter 23 - Sprint® Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 194
IOTA Error +WOAE
Description: This response indicates that an IOTA failure has occurred. Refer to Sprint® document SEBU
3G NAI dual launch v131 sec 1.2 for additional details.
Syntax:
Response Syntax: +WOAE: “IOTA error 1012”
Command Possible Responses
+WOAE: “IOTA error 1012”
Preparing Data Services +WOAP
Description: This response indicates that IOTA provisioning is in progress.
Syntax:
Response Syntax: +WOAP: “Preparing Data Services”
Command Possible Responses
+WOAP: “Preparing Data Services”
Please Retry +WOAR
Description: This response indicates that the previous attempt to start a data session should be retried.
When a data session is started without a valid profile, IOTA provisioning is initiated. Upon
completion of profile provisioning, this response is displayed.
Syntax:
Response Syntax: +WOAR: “Please Retry”
Command Possible Responses
+WOAR: “Please Retry”
Display PRI Checksum +WSUM
Description: This command is used to display the PRI checksum value. This checksum value is
calculated and programmed into the modem at the time of manufacture. The checksum
value is not updated or changed if a user modification is made to any of the PRI settings.
Syntax:
Command syntax: +WSUM?
Command Possible Responses
AT+WSUM?
Note: Display checksum
value. +WSUM: 0004DDCF
OK
Note: The displayed value is a eight digit hexadecimal number.