Multi-Tech Systems CDMA Wireless Modem - Manual (Page 193)

Chapter 23 - Sprint® Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 193
Proxy Address +WDPXY
Description: This command is used to read and write the proxy server address. The proxy server address
is required for IOTA connections.
Note: Following a software load, the AT+WPRR command must be used to establish the
default value.
Values:
<string>: 32 character maximum length string value in URL format.
Default: 68.28.31.1
Syntax:
Command syntax: AT+WDPXY=<address>
Command Possible Responses
AT+WDPXY?
Note: Display the current proxy server address value. 68.28.31.2
OK
AT+WDPXY=68.28.31.1
Note: Set the proxy server address value. OK
Note: New value set.
AT+ WDPXY =””
Note: Set invalid address value. +CERROR: BAD REQUEST
Note: Error message displayed.
WIOTA Connection Control +WIOTA
Description: This command is to start an IOTA session.
Values:
1: Connect – Start IOTA session to get profile.
Syntax:
Command syntax: AT+WIOTA=<value>
Command Possible Responses
AT+WIOTA=1
Note: Start IOTA session. OK
Note: Session started.
Sprint®. System Selection +WSSS
Description: This command is used to set the system selection and is persistent on reset. The values that
are available with the +WSSS command are dependent upon the currently loaded PRL.
Values:
<pref> Preferred only systems:
0: Home Only - Modem will operate on Sprint® PCS only.
1: Automatic - Roaming allowed on affiliated systems.
2: Analog only - Roaming rate applies.
Syntax:
Command syntax: +WSSS: <pref>
Command Possible Responses
AT+WSSS=?
Note: Show supported parameters +WSSS: (0-3)
OK
AT+WSSS?
Note: Get current setting +WSSS: 1
OK
AT+WSSS=0
Note: Set home only OK
Note: Home only mode set.