Multi-Tech Systems CDMA Wireless Modem - Manual (Page 98)

Chapter 14 – Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 98
Play Tone +WTONE
Description: This specific command allows a tone to be played on the current speaker or on the buzzer.
Frequency, volume and duration can be set.
Values:
<mode>
0: Stop playing.
1: Play a tone
<dest>: This parameter sets the destination (mandatory if <mode>=1)
1: Speaker
2: Buzzer
<freq>: This parameter sets tone frequency (in Hz) (mandatory if <mode>=1). The range is
between 1 and 4000Hz. However, for handset and a person to hear, the effective range may
be 150-4000Hz.
<volume>(0-3): This parameter sets the tone volume. The default value is 1. Values are the
same as +CRSL.
<duration> (0-50): This parameter sets tone duration (unit of 100 ms). When this parameter
is equal to 0 (default value), the duration is infinite, and the tone can be stopped by
AT+WTONE=0.
Syntax: Command syntax: AT+WTONE=<mode>[,<dest>,<freq>,<volume>,<duration>]
Command Possible Responses
AT+WTONE=1,1,300,2,50
Note: Play a tone OK
Note: Done
AT+WTONE?
Note: Current value +WTONE: 1,1,300,2,50
OK
AT+WTONE=0
Note: Stop playing OK
Note: Done
AT+WTONE=?
Note: Test command +WTONE: (0-1),(1-2),(1-4000),(0-3),(0-50)
OK
Note: Done