Multi-Tech Systems CDMA Wireless Modem - Manual (Page 105)

Chapter 14 – Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 105
Reset +WRST
Description: This command is used to reset the modem after the specified <delay> time period. The
<delay> value is entered in terms of hours and minutes.
Values:
<mode>
0: timer reset is disabled
1: timer reset is enabled
<Delay> specify the time for reset (hrs:mins)
“000:00”- “199:59”
<RemainTime> time before next reset
“000:00”- “199:59”
Syntax:
Command syntax: +WRST =<Mode>,<Delay>
Response Syntax: +WRST: <Mode>,<Delay>,<RemainTime>
Command Possible Responses
AT+WRST=? ERROR
AT+WRST=0
Note: Disable timer OK
AT+WRST=1,”001:03”
Note: Enable timer and put delay at
1 hour 3 minutes OK
AT+WRST? +WRST: 1,”001:03”,”001:01”
OK
Note: Timer activated to reset after 1 hour and 3 minutes. Actually 1
hour and 1 minute remaining before next reset.
Set Standard Tone +WSST
Description: This command is used to set/get the sound level of the Standard Tones.
Values:
<sound level>
0: Max volume (default)
4: Min volume (muted)
Syntax:
Command syntax: AT+WSST=<sound level>
Command Possible Responses
AT+WSST=0
Note: Set volume to Max. OK
AT+WSST=4
Note: Set the volume to Min (muted) OK
Note: Standard Tones are muted
AT+WSST?
Note: get current standard tones sound level +WSST: 4
OK
Note: Current level is 4
AT+WSST=?
Note: Display valid parameter range. +WSST: (0-4)
OK