Multi-Tech Systems CDMA Wireless Modem - Manual (Page 119)

Chapter 15 – SIM TOOLKIT
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 119
Values when Cmd=4 (Setup Call )
<Type>
0: Set up call but only if not currently busy on another call
1: Set up call, putting all other calls (if any) on hold
2: Set up call, disconnecting all other calls (if any)
<CalledNb> Called party number in ASCII format
<SubAdress> Called party sub-address in ASCII format
<Class>
0: Voice call
1: Data call
2: Fax call
Values when Cmd=5 (Play tone )
<ToneType>
0: Tone Dial
1: Tone Busy
2: Tone Congestion
3: Tone Radio ack
4: Tone Dropped
5: Tone Error
6: Tone Call waiting
7: Tone Ringing
8: Tone General beep
9: Tone Positive beep
10: Tone Negative beep
<TimeUnit>
0: Time unit used is minutes
1: Time unit used is seconds
2: Time unit used is tenths of seconds
<TimeInterval> (1 –255) Time required expressed in units
<TextInfo> Text information in ASCII format
Values when Cmd=6 (Sel Item )
<DefaultItem> (1 –255) Default Item Identifier
<Alpha Identifier menu> Alpha identifier of the main menu
<Idx> (1 –255) Identifier items
<NbItems> (1 –255) Number of items in the menu
<Alpha Idx Label> Alpha identifier label of items in ASCII format
<HelpInfo>
0: No help information available
1: Help information available
<NextActionId> Contains a pro-active command identifier.
Values when Cmd=7 (Refresh )
<RefreshType>
0: SlM initialization and full file change notification
1: File change notification
2: SIM initialization and file change notification
3: SIM initialization
4: SIM reset
Values when Cmd=8 (Send SS )
<TextInfo> Text information in ASCII format.
Values when Cmd=9 (Send SMS )
<TextInfo> Text information in ASCII format.
Values when Cmd=10 (Send USSD )
<TextInfo> Text information in ASCII format