Multi-Tech Systems CDMA Wireless Modem - Manual (Page 20)

Chapter 3 – Unsolicited AT Result Codes
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 20
Call Answered +WANS
Description: This response indicates that a voice call has been answered.
Values: <call type>
0: incoming call
1: outgoing call answered by other party (only available on networks supporting
answering supervision for payphone applications)
Syntax: Response syntax: +WANS:<call type>
Command Possible Responses
ATA +RING
OK
+WANS:0
Note: Incoming call answered
+WCNT:3
Call Connected +WCNT
Description: This unsolicited command indicates that an incoming or outgoing voice call has been
connected into a traffic channel state. If the service option is not available, +WCNT: will
output “NULL”.
Values: <so> Service option of call.
Speech: 3, 17, 32768
Loopback: 2, 9, 55
OTAPA: 18, 19
Position Determination: 35, 36
Syntax: Response syntax: +WCNT: <so>
Command Possible Responses
ATD18005551212; OK
+WORG:18005551212
+WCNT:3
Note: Call Connected with service option 3
Call Ended +WEND
Description: This response indicates that a voice call or attempt to establish a voice call has ended.
Values (for WISMO Quik 24xx) :
<reason>
0: Phone is offline
20: Phone is CDMA locked
21: Phone has no service
22: Call Faded/Dropped
23: Received Intercept from Base Station
24: Received Reorder from Base Station
25: Received a Release from Base Station (This is a normal call termination).
26: Service Option rejected by Base Station
27: Received Incoming Call
28: Received an alert stop from Base Station
29: Software ended the call (Normal release).
30: Received End Activation – OTASP calls only.
31: Internal Software aborted the origination/call.
32: Maximum Access probes exhausted (The modem failed to contact the Base Station)
34: RUIM not present