Multi-Tech Systems CDMA Wireless Modem - Manual (Page 48)

Chapter 6 – Network Service Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 48
Change NAM Selection +WNAM
Description: This command is used to request a change in the NAM (Number Assignment Modem )
selection. The modem supports up to 4 NAMs. However, if a NAM is not fully programmed,
the modem will not switch to the requested NAM. The default NAM for the modem is 1. The
response to this command is only OK, and is no guarantee that the NAM will change. If the
NAM selection request is accepted, the unsolicited command +WNAM: <nam> will be
returned. If or when the actual NAM changes, the unsolicited command +WCNM: <nam> will
be returned. See Unsolicited Result Codes in Chapter 3.
Values: <nam>
1: NAM 1
2: NAM 2
3: NAM 3
4: NAM 4
5: Auto NAM
Syntax: Command syntax: AT+WNAM=<nam>
Command Possible Responses
AT+WNAM=2
Note: Use NAM 2, if
programmed OK
+WNAM: 2
+WCNM: 2
AT+WNAM=3
Note: Use NAM 3, if
programmed OK
Note: No unsolicited response indicates that
NAM 3 is not valid, thus no change in NAM.
AT+WNAM=5
Note: Try Auto NAM OK
+WNAM: 5
+WCNM: 1
Note: Auto NAM is selected, NAM 1 chosen.
AT+WNAM? +WNAM: 1
AT+WNAM=? +WNAM: (1-5)
Read Current NAM +WCNM
Description: This command is used to read the current NAM (Number Assignment Modem). The modem
supports up to 4 NAMs. Also, note that there exists an unsolicited command +WCNM:
<nam> that is returned any time the NAM changes. See Unsolicited Result Codes in
Chapter 3.
Syntax: Command syntax: AT+WCNM
Command Possible Responses
AT+WCNM
Note: Ask for the current NAM +WCNM: 1
OK
Note: NAM 1 in use