Multi-Tech Systems CDMA Wireless Modem - Manual (Page 58)

Chapter 8 – Short Messages Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 58
New Message Indication +CNMI
Description: This command selects the procedure for message reception from the network.
Values <mode>
The <mode> value controls the processing of unsolicited result codes. Only mode 2 is
supported at this time. The other mode values are accepted and return OK but the
processing of unsolicited result codes will be the same as with mode value 2.
0: Buffer unsolicited result codes in the TA. If the TA result code buffer is full,
indications can be buffered in some other place or the oldest indications may be
discarded and replaced with the new received indications
1: Discard indication and reject new received message unsolicited result codes when
TA-TE link is reserved. Otherwise forward them directly to the TE
2: Buffer unsolicited result codes in the TA when TA-TE link is reserved and flush them
to the TE after reservation. Otherwise forward them directly to the TE
3: Forward unsolicited result codes directly to the TE. TA-TE link specific in band used
to embed result codes and data when TA is in on-line data mode
<mt> sets the result code indication routing for SMS-DELIVERs. Default is 2.
0: No SMS-DELIVER indications are routed.
1: SMS-DELIVERs are routed using unsolicited code: +CMTI: “MT”, <index>
2: SMS-DELIVERs (except class 2 messages) are routed using unsolicited code:
+CMT: <oa>, <scts>, <tooa>, <lang>, <encod>,
<priority>[,<cbn>],<length><CR><LF><data> (text mode)
<bm> sets the result code indication routing for received Cell Broadcast Messages. Default
is 2.
0: No CBM indications are routed to the TE. The CBMs are stored.
1: The CBM is stored and an indication of the memory location is routed to the
customer application using unsolicited result code: +CBMI: “BC”, <index>
2: New CBMs are routed directly to the TE using unsolicited result code (format
matches that of +CBM: <oa>, [<alpha>,] <scts> [,<tooa>, <length>]
<CR><LF><data> (text mode)
<ds> sets the routing for SMS-STATUS-REPORTs. Default is 1.
0: No SMS-STATUS-REPORTs are routed.
1: SMS-STATUS-REPORTs are routed using unsolicited code: +CDS: <fo>, <mr>,
[<ra>] , [<tora>], <scts>, <dt>, <st> (Text mode)
2: SMS-STATUS-REPORTs are stored and routed using the unsolicited result ode:
+CDSI: “SR”, <index>
<bfr> Default is 0.
0: TA buffer of unsolicited result codes defined within this command is flushed to the
TE when <mode> 1…3 is entered (OK response shall be given before flushing the
codes)
1: TA buffer of unsolicited result codes defined within this command is cleared when
<mode> 1…3 is entered.