Multi-Tech Systems CDMA Wireless Modem - Manual (Page 138)

Chapter 17 – Extended AT Commands in IS707.3
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 138
Modulation Automode Control +MA
Description: The extended-format compound parameter is a list of modulations that the DCE may use to
connect with the remote DCE in automode operation, for answering or originating data calls.
Syntax:
Command syntax: AT+MA=[<carrier>[,<carrier>[,<carrier>[,…]]]]
Command Possible Responses
AT+MA?
Note: Display the parameter information. +MA: V32, V32B
Note: Command is valid
AT+MA=?
Note: Display the range of parameters +MA: (V32B,V32,V26B,V22B,V22,V21)
Note: Command is valid
AT+MA=V32
Note: Set to V32 OK
Note: Command is valid
Modulation Reporting Control +MR
Description: The extended-format numeric parameter controls whether the extended-format
+MCR:<carrier> and +MRR:<rate> intermediate result codes are transmitted from the IWF to
the mobile station.
Values:
<Val>
0: Disables reporting of modulation connection
1: Enables reporting of modulation connection (+MCR and +MRR are transmitted)
Syntax:
Command syntax: AT+MR=[<Val>]
Command Possible Responses
AT+MR?
Note: Display the current setting. +MR: 0
Note: Command is valid
AT+MR=?
Note: Display the range of setting. +MR: (0,1)
Note: Command is valid
AT+MR=1
Note: Enable reporting. OK
Note: Command is valid
V.18 Reporting Control +MV18R
Description: The extended-format numeric parameter controls whether the extended-format +MV18R:
result code is transmitted from the IWF to the mobile station.
Values:
<Val>
0: Disables reporting of V.18 connection
1: Enables reporting of V.18 connection
Syntax:
Command syntax: AT+MV18R=[<Val>]
Command Possible Responses
AT+MV18R?
Note: Display the current
setting. +MV18R: 0
OK
Note: Command is valid
AT+MV18R=1
Note: Enable reporting. OK
Note: Command is valid