Yokogawa EJX440A - Manual (Page 25)

<3. Operation>
3-15
IM 01C25T01-01E
Note that following symbols are not available:
# % & < > . * : + -
The integral indicator shows “-- -- -- -- -- --” when
these are entered.
Engr LRV and Engr URV are used to set the lower
and upper range values for the engineering unit
display. When the insrument is shipped, these are
set as specified in the order.
F0323.ai
Call up the Engr LRV Display.
Set –50, and press ENTER (F4).
EJX:YOKOGAWA
Engr LRV
0.0
-50
DEL DEL ESC ENTER
EJX:YOKOGAWA
Engr disp range
1 Engr LRV -50
2 Engr URV 100
3 Engr exp ×1
4 Engr Unit M
5 Engr point 1
HELP SEND HOME ENTER
Press to select engr disp URV.
EJX:YOKOGAWA
Engr URV
100.0
50
DEL DEL ESC ENTER
Set 50, and press ENTER (F4).
HELP
(ENTER)
‘– 5 0’
(ENTER)
‘5 0’
(SEND)
1. Device setup
4. Detailed setup
4. Display condition
4. Engr disp range
1. Engr LRV and 2. Engr URV
Example: Set lower range value (LRV) to –50 and upper
range value (URV) to 50.
1
2
EJX:YOKOGAWA
Engr disp range
1 Engr LRV -50
2 Engr URV 50
3 Engr exp ×1
4 Engr Unit M
5 Engr point 1
HELP SEND HOME ENTER
4
3
Press SEND (F2) to send the data
to the transmitter, then check to
confirm that disappears.
(SEND)
SEND
3.5.4 Unit for Displayed Temperature
When the instrument is shipped, the temperature
units are set to C (Centigrade). Follow the
procedure below to change this setting.
When this parameter is set, it also changes the
temperature unit for Snsr temp at Process
variables and Amp temp at Temp sensor.
F0325.ai
(ENTER)
EJX:YOKOGAWA
Temp Unit
degC
degC
degF
Kelvin
HELP SEND ESC ENTER
Select degF (Fahrenheit), and
Press ENTER (F4).
1. Device setup
4. Detailed setup
1. Sensors
3. Temp sensor
3. Temp Unit
Example: Change the unit for the temperature display from
degC to degF.
EJX:YOKOGAWA
Temp sensor
1 Snsr temp 23 degC
2 Amp temp 23 degC
3 Temp Unit degF
HELP SEND HOME ENTER
2
1
Press SEND (F2) to send the data
to the transmitter, then check to
confirm that disappears.
(SEND)
SEND