Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 102)

IM 11M13A01-04E 8-14
8.7 Other Settings
8.7.1 Setting the Date-and-Time
The following describe how to set the date-and-time. Automatic calibration works
following this setting.
Use parameter code “F10” to set the date-and-time.
Table 8.14 Data-and-time Settings
T8.14E.EPS
ٙ ٙ
ENT F 1 0
> ٙ
ENT 0 0.01.01
> ٙ
ENT 00.0 1 .01
>
ٙ
ENT 00.0 6 .01
> ٙ
ENT 00.06. 0 1
> ٙ
ENT 00.06. 2 1
>
ٙ
ENT 00.06.2 1
> ٙ
ENT 0 7.18
> ٙ
ENT 14.3 0
>
ٙ
ENT 14.30
> ٙ
ENT 14.30
> ٙ
ENT F 10
Select the parameter code " F10. "
If you touch the [ ENT ] key, the current date will be displayed. The display
on the left indicates the date - January 1, 2000. To set June 21, 2000, follow
the steps below:
Touch the [
>
] to move the position of the digit that is flashing to the right.
Touch the [ ٙ] key to change to 6.
Touch the [
>
] key to move the position of the digit that is flashing to the
right one digit.
Touch the [ ٙ] to change to 2.
Touch the [
>
] key to move the position of the digit that is flashing to the
right one digit.
Let the rightmost character flash, and touch the [
>
] key to display the time.
Continuously touch the [
>
] key, then the date and time are alternately
displayed. Displayed on the left is 7:18 a.m.
Omitted here.
Touch the keys and enter the current time in same way as the date has
been entered, on a 24-hour basis. 2:30 p.m. Displayed on the left means 2:40 p.m.
If you touch the [ ENT ] key, all the digits flash.
Touch the [ ENT ] key again to set the time.
If you touch the [
>
] and [ ENT ] keys together, the parameter code selection display
appears.
Switch operations Display Brief description
The symbol ( ) indicates that the key is being touched. Light characters indicate that the digits are flashing