Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 78)

IM 11M13A01-04E 7-14
7.8 Checking Current Loop
The set current can be output as an analog output. This enables the checking of wiring
between the converter and the receiving instrument. Current loop checking is performed
using parameter code G01.
Table 7.8 Checking Current Loop
T7.7E.EPS
Switch operation Display Description
>
>
>
>
>
>
>
>
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
A 01
G 01
0 0.0
1 0.0
1 0.0
1 0.0
G 01
Basic
panel
display
Ͼ
Ͼ
Ͼ
Ͼ
Ͼ
Ͼ
Ͼ
Display after the password has been entered.
Touch the [ ] key to switch to Group F.
Touch the [ ENT ] key. The output current remains preset
with the output-hold feature (Section 2.3).
Touch the [ ] key to set the numeric value 1 (to set a 10-mA output).
Touch the [ ENT ] key to have all the digits flash.
Touch the [ ENT ] key again to stop the flashing.
A 10-mA output is then issued.
Touch the [ ENT ] key once again to switch
to the parameter code selection display.
At that point, the output current returns to the normal value.
Touch the [>] key together with the [ ENT ] key
to return to the basic panel display.
The symbol [ ] indicates that the corresponding keys are being touched, and the light characters indicate flashing.
ٙ
ٙ