Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 117)

<10. Other Functions>
10-8
IM 11M12A01-04E
10.3 Initialization Procedure
Follow the table below to initialize parameters. The password for initialization is 1255.
Table 10.5 Initialization Procedure
Switch operation Display Description
> ∧
ENT F 3 0
Enter the parameter code for the item to be initialized.
The following show an example of entering "F30."
(Previous needed operations are omitted.)
> ∧
ENT 0 000
Touch the [ENT] key to switch to the password entry display.
> ∧
ENT 1 000
Enter the password 1255 for initialization.
> ∧
ENT 1 0 00
> ∧
ENT 1 2 00
> ∧
ENT 12 0 0
> ∧
ENT 12 5 0
> ∧
ENT 125 0
> ∧
ENT 125 5
> ∧
ENT 1255
After you enter the password and then touch the [ENT] key, all the digits
flash.
> ∧
ENT USr Go
Touch the [ENT] key again to display "USr Go."
> ∧
ENT USr Go
Touch the [ENT] key once more. All the digits then flash for two to three
seconds, and data initialization starts.
> ∧
ENT F 30
The initialization is complete, and the parameter code selection display
then appears.
The symbol ( ) indicates that the keys are being touched, the light characters indicates flashing.
WARNING
• Do not attempt to turn off the equipment power during initialization (while “USr Go” is flashing).