Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 120)

<5. Display and Operations while Connected to GC1000 Mark II>
5-10
IM 11B06C01-01E
5.2.3 Displaying Detector Status
Right clicking on the detector area of the valve display control section, or left clicking the
temperature controller display causes a detector signal or temperature controller status to be
displayed respectively. The updating cycle of these displays is 3 seconds.
SEE ALSO
For changing the operation of the valve display control section, see section 3.6.
n Detailed Display of Detector Signal(s)
l Display procedure
If there are two detectors, you can select one of them in the valve display control section.
(1) Move the mouse cursor over the desired detector area of the valve display control section
and right click.
The Detector Signal Display window appears.
Valve display control section
F5-2-8.ai
Detector Signal
Display window
Right click Close command
(2) To exit the Detector Signal Display window, click on the Close command in the Control
menu.
l Window elements (Detector Signal Display window)
F5-2-9.ai
5th Edition : Nov. 16, 2011-00