Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 92)

<4. Display and Operations while Connected to GC8000>
4-45
IM 11B06C01-01E
4.4.18 Set Mark Dialog Box
Select the Set Mark command in the Graph menu to display the Set Mark dialog box.
From this dialog box, you can turn display of gate marks, peak marks, and start marks on or off,
set whether to display or hide additional information, and select the information.
Figure 4.52 Set Mark dialog box
• If the “Peak ON/OFF” check box is selected, the peak ON/OFF information of the
corresponding chromatogram is displayed.
• If the “Gate ON/OFF” check box is selected, the gate ON/OFF information of the
corresponding chromatogram is displayed.
• With additional information 1 and 2, you can select two items to be displayed on the
Chromatogram window for each peak. Select from peak number, component name, gain,
range, and standard concentration. The display position is the highest point between the
gate ON time and the gate OFF time.
• Additional information 2 is displayed on the top of additional information 1.
• If you have selected the same item in additional information 1 and 2, the same information is
displayed twice.
• If the smart mark check box is selected, the smart mark appears, in tandem display mode,
at the separator section in system analysis cycles. The smart mark check box is not
displayed in single display mode.
CAUTION
• The peak ON/OFF information, gate ON/OFF information, and additional information are
not provided for a differential chromatogram, and therefore the relevant check boxes and
combo boxes are not displayed.
• When the GC1000 MarkII chromatogram file is displayed, combo boxes for additional
information 1 and 2 are not displayed because it does not have additional information.
• In a file chromatogram not intended for tandem display, a saved chromatogram, a baseline
chromatogram, and a differential chromatogram, the smart mark check box is not displayed.
5th Edition : Nov. 16, 2011-00