HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 116)

the data. We also recommend that you specify info as the severity level for
the extended facility. This example shows how to specify the recommended
settings in the /etc/syslog.conf or /etc/rsyslog.conf file:
local0.info /usr/local/audlog
Set Up VxVM
To use HDLM and VxVM on the same host, set up VxVM as follows:
1
.
Make sure that the logical device file under the /dev/dsk and /dev/rdsk
directories is backed up.
If the information is not backed up, perform step 4 in
Performing
Operations on Devices to Be Managed by HDLM on page 3-45 in
Preparations for a New Installation of HDLM on page 3-45 .
2
.
If a created disk group already contains a device that is to be managed by
HDLM, deport the disk group.
For details, refer to the VxVM documentation. You can use the disk group
again by importing the deported disk group after installing HDLM.
3
.
When used with the Thunder 9500V Series, Lightning 9900V Series,
Hitachi USP series, Hitachi AMS2000/AMS/WMS/SMS Series, Universal
Storage Platform V/VM series, or Virtual Storage Platform series install
the Array Support Library of VxVM before installing HDLM.
For details, see the storage system manual.
4
.
After installing VxVM, confirm that no disk group containing sd or ssd
devices to be managed by HDLM has been registered in bootdg.
If the disk group containing the sd or ssd device to be managed by HDLM
has been registered in bootdg, perform one of the following:
¢
Use a VxVM command to remove the HDLM-managed sd or ssd device
from the disk group.
¢
Remove the target disk group from the bootdg registration
For details, refer to the VxVM documentation.
5
.
Remove any sd or ssd disk to be managed by HDLM from VxVM control.
For details on how to remove any such sd or ssd device from VxVM
control, refer to the VxVM documentation. If HDLM has been installed,
remove any such sd or ssd device from VxVM control as directed in
Removing Devices from VxVM on page 3-160 .
Set Up SDS and SVM
When SDS or SVM uses the sd or ssd device to be managed by HDLM, clear
the device settings. For details, refer to the SDS or SVM documentation.
If you plan to use a SDS or SVM shared diskset, make sure that the hardware
configurations of all the hosts are identical (host type; HBA type, number,
slots; the number of paths and the HUBs and switches through which each
path passes; and the storage ports and LUN used by each LU).
3-50
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide