HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 54)

Log name Description Output destination
file /etc/syslog.conf or /etc/
rsyslog.conf are collected.
#
We recommend that you configure
the system so that information at
the Information level and higher is
output.
Syslogs can be checked using a text
editor.
The syslog file path is
specified in the file /etc/
syslog.conf or /etc/
rsyslog.conf. For details,
refer to the Solaris
documentation.
#
When you want to configure the system so that HDLM messages are
output to syslog, specify user for the facility in the /etc/syslog.conf
or /etc/rsyslog.conf file. The following shows an example where the
system function name is user, and messages at the info level or higher
are output to the /tmp/syslog.user.log file:
user.info /tmp/syslog.user.log
For details on error levels, see Filtering of Error Information on page 2-32 .
Filtering of Error Information
Errors detected by HDLM are classified into various error levels. The following
table lists and describes the error levels, in the order of most to least severe
to the system.
Table 2-7 Error Levels
Error level Meaning
Level output in
syslog
Critical Fatal errors that might stop the system. error
Error Errors that adversely affect the system. This
type of error can be avoided by performing a
failover or other countermeasures.
error
Warning Errors that enable the system to continue
but, if left, might cause the system to
improperly operate.
warning
Information Information that simply indicates the
operating history when the system is
operating normally.
info
Error information is filtered by error level, and then collected.
The error level is equivalent to the level of the messages output by HDLM.
For details on the level of the message, see Format and Meaning of Message
IDs on page 8-3 .
2-32
HDLM Functions
Hitachi Dynamic Link Manager (for Solaris) User Guide