HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 118)

f
.
At another node in the same cluster, switch to become the superuser,
and then place the node that was stopped in step 5 into the
maintenance mode.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,maintstate
g
.
Confirm that the cluster node is in the maintenance mode.
Make sure that the node that is in the maintenance node has the
following status:
- The node is in the Offline status.
- Both the current Quorum votes present and Quorum votes
possible are 0.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scstat -q
h
.
If the cluster is a two-node configuration, enter the install mode.
If the cluster consists of three or more nodes, this step is not
necessary so go to step 9. The following shows an example of
executing the command:
host2# /usr/cluster/bin/scconf -c -q installmode
i
.
Release the settings of the last Quorum device.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -r -q globaldev=Quorum-
device's-device-ID
j
.
At a node that is not in the maintenance mode, switch to become the
superuser.
If the cluster consists of two nodes, go to step 12. If the cluster
consists of three or more nodes, go to step 11.
k
.
If the cluster consists of three or more nodes, reset the cluster
Quorum votes.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset
l
.
Change the mode of the node, which you changed into the
maintenance mode, back to the previous mode.
At the ok prompt, execute boot.
m
.
If the cluster consists of two nodes, make sure that the node (which
was changed into the maintenance mode) that you want to change
back to the previous mode is active, and then reset the cluster
Quorum votes. If the cluster consists of three or more nodes, this step
is not necessary.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset
Setting up a Solaris 11 environment
Verifying the publisher of a package
3-52
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide