HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 471)

Key name #1 Explanation #2
Required or
optional?
Maximum
length
(characte
rs)
Required
for new
installatio
n
Required
for
upgrade
installati
on or re-
installati
on
about the switching of
controllers performed by the
storage system.
#5
You can set the checking
interval from 1 to 1440. The
default is 10.
Legend:
Optional: If you omit the key name and value, the following value is
used:
¢
For a new installation
The default is used.
¢
For an upgrade installation or re-installation
The previous setting value is inherited.
Note
Audit log settings are not supported.
#1
Only one key name and value can be specified on each line.
#2
Specifying an invalid value causes an error.
For details on the settings functionality, see
set (Sets Up the Operating
Environment) on page 6-17 .
#3
You can specify this key only in the following cases:
¢
For a new installation:
When on is specified for the auto_failback key in the installation
information settings file
¢
For an upgrade installation or re-installation:
When on is specified for the auto_failback key in the installation
information settings file, or when automatic failback is enabled in the
installation pre-settings
#4
If you want to enable intermittent error monitoring, specify this key after
specifying the auto_failback and auto_failback_interval keys.
Utility Reference
7-41
Hitachi Dynamic Link Manager (for Solaris) User Guide