HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 332)

You can check the LU and verify that the disk label is specified by using
the format command. Figure 4-16 Example of executing the format
command on page 4-64 shows an example of executing the format
command. The shaded portion represents the LU to be managed by
HDLM.
Figure 4-16 Example of executing the format command
In the above execution example, when you specify an LU, the message
Disk not labeled. Label it now? will be output if a disk label has not
been specified. In this case, enter y and specify a disk label.
3
.
If setup is performed for Quorum devices and disk device groups in the
LU to be managed by HDLM, release the LU settings.
When you unregister the SDS or SVM diskset, the diskset data will be
deleted so first back up any necessary data. For details on how to release
settings for Quorum devices and VxVM disk groups, see Remove Solaris
Cluster Settings on page 3-186 of Preparations for HDLM Removal on
page 3-185 .
For details on how to release SDS or SVM disksets, see Remove SDS
Settings on page 3-189 or Remove SVM Settings on page 3-190 of
Preparations for HDLM Removal on page 3-185 .
4
.
Make sure that registration is performed for the key used in disk
reservation for the LU to be managed by HDLM.
Execute the following command on any node:
# /usr/cluster/lib/sc/scsi -c inkeys -d the-name-of-the-logical-
device-file-of-slice-2-of-the-LU-to-be-managed-by-HDLM
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c inkeys -d /dev/rdsk/
c3t50060E80033A9902d2s2
4-64
HDLM Operation
Hitachi Dynamic Link Manager (for Solaris) User Guide