HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 281)

Permanent -
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
For details on the displayed items and their descriptions, see view (Displays
Information) on page 6-34 .
Updating the License
This section explains how to update the license.
To update the license, execute the dlnkmgr command's set operation with
the -lic parameter specified. When the confirmation message is displayed,
enter y to execute, or n to cancel the command. If the license key file does
not exist, a message asking you to enter the license key appears, so enter
the license key.
Note:
When you are executing the dlnkmgr command's set operation with the -
lic parameter to install the license, you can only execute it once at a
time. If you attempt to execute the dlnkmgr command containing the set
operation with the -lic parameter more than once, a core file is created
and the following message may appear:
KAPL01075-E A fatal error occurred in HDLM. The system
environment is invalid.
If this message appears, execute the dlnkmgr command's view operation
with the -sys -lic parameter to make sure that the license is installed
correctly.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation name
= set [y/n]: y
KAPL01071-I A permanent license was installed.
#
Viewing HDLM Version Information
This section explains how to display HDLM version information.
To display HDLM version information, execute the dlnkmgr command's view
operation with the -sys parameter specified. The following shows an example
of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
HDLM Operation
4-13
Hitachi Dynamic Link Manager (for Solaris) User Guide