HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 287)

Execute the following command to display the driver configuration
information, and then refer to the instance field of the HDLM driver
obtained in step 1 (the driver name of the HDLM driver is dlmfdrv).
Identify the path used to determine the HDLM logical device file name of
the LU from the FilterPath property.
# /usr/sbin/prtconf -vP
The following shows an example of executing the command.
This example shows the information on instance 1 of the HDLM driver
(the driver name of the HDLM driver is dlmfdrv), which is contained in
the output results of the prtconf command.
The shaded portion is the physical device file name of the sd or ssd driver
of the path used to determine the HDLM logical device file name.
Switching the Kernel Mode
If you switch the kernel mode from 32 bits to 64 bits when only the 32-bit
version of HDLM is installed, you must re-install HDLM after the switch is
completed.
For details on how to switch the kernel mode currently being used, see
Switch the Kernel Mode on page 3-48 of Preparations for a New Installation of
HDLM on page 3-45 .
When the Path Configuration Is Changed in a Boot Disk Environment
When HDLM changes the path used to determine the logic device file name of
an HDLM device, perform the procedures below. If this procedure is not
performed, the disk might fail to boot because the name of the physical
device file corresponding to the logical device file changed. To obtain the path
that HDLM uses to determine the logic device file name of an HDLM device,
execute the procedure described in When the Path Configuration Is Changed
on page 4-17 .
1
.
Migrate to the local boot disk environment, following the procedure
described in Migrating from a Boot Disk Environment to the Local Boot
Disk Environment on page 3-116 .
2
.
Change the path configuration.
HDLM Operation
4-19
Hitachi Dynamic Link Manager (for Solaris) User Guide