HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 470)

Key name #1 Explanation #2
Required or
optional?
Maximum
length
(characte
rs)
Required
for new
installatio
n
Required
for
upgrade
installati
on or re-
installati
on
off: Disable automatic
failback.
auto_failback_int
erval Specify the path status check
interval, which is the interval
between the end of the
previous check and the start
of the next check, in minutes.
You can specify a value from
1 to 1440. The default is 1.
Optional Optional 4
intermittent_erro
r_monitor
#3#4
Specify whether to enable
intermittent error monitoring
by specifying either of the
following values:
on: Enable intermittent error
monitoring.
off: Disable intermittent
error monitoring (default).
Optional Optional 3
intermittent_erro
r_monitor_interva
l
#4
Specify the interval for
intermittent error monitoring
in minutes.
You can specify a value from
1 to 1440. The default is 30.
Optional Optional 4
intermittent_erro
r_monitor_number
#
4
Specify how many times an
error must occur to cause
HDLM to assume an
intermittent error.
You can specify a value from
1 to 99. The default is 3.
Optional Optional 2
dynamic_io_path_c
ontrol Specify whether to enable or
disable the dynamic I/O path
control function by using the
values below. Note that, if
this function is set, the
setting for each storage
system or LU is cleared.
on: Enabled
off: Disabled (default)
Optional Optional 3
dynamic_io_path_c
ontrol_interval
#5
For the dynamic I/O path
control function, specify the
checking interval (in minutes)
for reviewing the information
Optional Optional 4
7-40
Utility Reference
Hitachi Dynamic Link Manager (for Solaris) User Guide