HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 190)

• Slice 0: / (root) file system
• Slice 1: Swap device and dump device
• Slice 6: /usr file system
• Slice 7: SVM state database
1
.
Prepare another LU with the same capacity as that of the created boot
disk, and make the configuration and capacity of slices the same.
2
.
Create the SVM state database.
# matadb -a -f c8t50060E08000436D1d4s7
# metadb -a c8t50060E08000436D1d5s7
3
.
Decide the metadevice names.
In this procedure, specify the settings as follows:
¢ / (root) file system
d10(mirror) ---- d11(submirror),d12(submirror)
¢
swap
d20(mirror) ---- d21(submirror),d22(submirror)
¢
/usr
d30(mirror) ---- d31(submirror),d32(submirror)
4
.
Create metadevices for / (root), swap, and /usr, and then mirror each of
them (single mirror).
# metainit -f d11 1 1 c8t50060E08000436D1d4s0
# metainit d10 -m d11
# metainit -f d21 1 1 c8t50060E08000436D1d4s1
# metainit d20 -m d21
# metainit -f d31 1 1 c8t50060E08000436D1d4s6
# metainit d30 -m d31
5
.
Edit the file /etc/vfstab to change the swap definition to the
metadevice /dev/md/dsk/d20, and the /usr definition to the
metadevice /dev/md/dsk/d30.
Before change:
/dev/dsk/c8t50060E08000436D1d4s1 - swap - no
-
/dev/dsk/c8t50060E08000436D1d4s6 /dev/rdsk/
c8t50060E08000436D1d4s6 /usr ufs 1 no -
After change:
/dev/md/dsk/d20 - swap - no -
/dev/md/dsk/d30 /dev/md/rdsk/d30 /usr ufs 1 no -
6
.
Set the dump device.
# dumpadm -d /dev/md/dsk/d20
3-124
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide