HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 186)

Before editing
DUMPADM_DEVICE=/dev/dsk/c8t50060E80004361D1d1s1
After editing
DUMPADM_DEVICE=/dev/dsk/c0t0d0s1
17
.
Boot the system from the post-migration environment.
¢
Skip to step 18 if SDS or SVM is being used and you are migrating a
replica of the SDS or SVM state database to the post-migration
environment. In this case, keep the pre-migration environment
recognized by Solaris.
¢
Skip to step 21 if SDS or SVM is being used but you are not migrating
a replica of the SDS or SVM state database.
¢
Skip to step 21 if SDS or SVM is not being used.
18
.
Check the state database settings.
An example is shown below.
19
.
Add the post-migration boot disk to the SDS or SVM state database.
An example is shown below.
20
.
Delete the SDS or SVM state database replica that exists in the pre-
migration boot disk.
An example is shown below.
21
.
Perform the required settings if you want to mirror or multi-path the post-
migration boot disk in the following applications.
For details on the required settings, see the documentation for the
relevant application.
¢
SDS
¢
SVM
3-120
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide