HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 220)

A screen to set the monitoring interval for the number of messages
output to the integrated trace file appears. The current value is displayed
in Current Span (sec).
2
.
Enter a desired interval in New Span(sec).
You can specify a value from 0 to 3600 (seconds). The default and
recommended value is 0.
If you do not want to change the monitoring interval, leave New
Span(sec) blank, type !, and then press the Enter key to return to the
Hitachi Network Objectplaza Trace Library setup menu.
Note that when you specify a monitoring interval of 0, even if you specify
the maximum number of messages in 7: Max messages per span, the
amount of integrated trace information to be output will not be adjusted.
3
.
Press the Enter key.
The new setting is applied and the Hitachi Network Objectplaza Trace
Library setup menu appears again.
4
.
In the Hitachi Network Objectplaza Trace Library setup menu, type 7, and
then press the Enter key.
A screen to set the maximum number of messages output to the
integrated trace file based on the monitoring interval specified in 6:
Lookout span appears. The current value is displayed in Current
Max(sec).
5
.
Adjust the maximum number of messages output to the integrated trace
files in New Max(sec).
The default is 0. You can specify a value from 0 to 500 (messages). If you
want to increase the number of messages that are output to the
integrated trace file as much as possible, we recommend that you set this
value to 0.
When you specify a monitoring interval of 0 in 6: Lookout span, the
value set in New Max(sec) will be disregarded.
Also, when you specify a value of 0 for New Max(sec), even if you
specify the monitoring interval in 6: Lookout span, the maximum
number of messages output will not be adjusted.
3-154
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide