HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 130)

If no key is displayed, perform the steps beginning with step 11.
7
.
Stop all nodes that comprise the cluster. On any one node, execute the
following command:
# /usr/cluster/bin/scshutdown -g0 -y
8
.
Start all nodes comprising the cluster in non-cluster mode.
Execute boot -x at the ok prompt.
9
.
Cancel the key registration for the device to be managed by HDLM.
On any one node, execute the following command:
# /usr/cluster/lib/sc/scsi -c scrub -d slice-2-logical-device-
file-name-for-the-device-to-be-HDLM-managed
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c scrub -d /dev/rdsk/c5t0d0s2
Reservation keys currently on disk:
0x40235c5200000002
0x40235c5200000001
0x40235c5200000003
Attempting to remove all keys from the disk...
Scrubbing complete, use '/usr/cluster/lib/sc/scsi -c inkeys -
d /dev/rdsk/c5t0d0s2' to verify success
#
10
.
Make sure that the key registration was canceled for the device to be
managed by HDLM.
On any one node, perform step 6 again and confirm that no key is
displayed.
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c inkeys -d /dev/rdsk/c5t0d0s2
Reservation keys(0):
#
In this example, key registration is canceled.
11
.
Insert the DVD-ROM and install HDLM on all nodes that comprise the
cluster.
After a few seconds, the DVD-ROM will be automatically mounted, and
the mount point of the DVD-ROM will be displayed in a list of files.
If the DVD-ROM cannot be automatically mounted, execute the following
command to mount the DVD-ROM:
# mount -F hsfs -o ro DVD-ROM-device-name DVD-ROM-mount-point
The following shows an example of executing the command for mounting
the DVD-ROM:
# mkdir /cdrom/cdrom0
# mount -F hsfs -o ro /vol/dev/dsk/c0t6d0/DVD-ROM-volume-name /
3-64
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide