HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 357)

the Offline(C) status, enter y. Otherwise, enter n. [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
#
-chaid CHA-port-ID
Use this parameter to place offline, at one time, all paths that pass
through a specific CHA port. The command will place offline all paths
connected to the CHA port that has the specified CHA-port-ID. Paths that
pass through a specific CHA port on a storage system recognized by the
operating system will be offline. If there are multiple physical CHA ports
that correspond to the CHA port ID, use -cha -pathid AutoPATH_ID to
place paths offline. To display the CHA port IDs, execute the following
view operation:
# /opt/DynamicLinkManager/bin/dlnkmgr view -cha
For details about how to execute the view operation to display the CHA
port IDs, see
To display CHA port information on page 6-71
in Parameters on page 6-36 .
Example
The following example shows how to place offline all paths connected
to the CHA port whose CHA-port-ID is 00001.
# /opt/DynamicLinkManager/bin/dlnkmgr offline -chaid 00001
KAPL01102-I All the paths which pass the specified CHA port
will be changed to the Offline(C) status. Is this OK? [y/n]:y
KAPL01103-I If you are sure that there would be no problem
when all the paths which pass the specified HBA port are
placed in the Offline(C) status, enter y. Otherwise, enter
n. [y/n]:y
KAPL01061-I 15 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
#
-pathid AutoPATH_ID
Use this parameter to place a single path offline.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details on the view operation, see view
(Displays Information) on page 6-34 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID). Therefore, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the dlmcfgmgr utility.
Always make sure that you execute the view operation to find the current
AutoPATH_ID of the target path, before executing the offline operation.
Command Reference
6-9
Hitachi Dynamic Link Manager (for Solaris) User Guide