HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 266)

File System Settings
For the file systems of the LUs that were managed by HDLM, specify settings
that allow the Solaris sd or ssd driver to be mounted or specify settings that
allow volume manager's volumes to be mounted after setup is performed
again.
After removing HDLM, the ZFS file system that was exported before the
removal can be imported for use.
Application Program Settings
For the application programs that were using HDLM devices, specify the
device file of the Solaris sd or ssd driver.
Removing Hitachi Network Objectplaza Trace Library (HNTRLib2)
When you remove HDLM, if the KAPL09019-E or KAPL09020-E message is
output, follow the procedure below to remove HNTRLib2.
To remove HNTRLib2:
1
.
Log in to Solaris as a user with root permissions.
2
.
Execute the following command to unregister the name of the bundled
program products:
# /opt/hitachi/HNTRLib2/etc/hntr2cancel "Hitachi Dynamic Link
Manager"
3
.
Execute the following command:
# /opt/hitachi/HNTRLib2/etc/hntr2setup
The HNTRLib2 setup menu will be displayed.
4
.
From the setup menu, select 9.
HNTRLib2 will be removed.
If HNTRLib2 is not being used by any other programs:
HNTRLib2 will be removed normally, and the following message will be
displayed.
Unsetup is complete.
If HNTRLib2 is being used by another program:
HNTRLib2 will not be removed, and the following message will be
displayed.
Because a bundle PP name is registered,
I did not do the Uninstall.
If HNTRLib2 was not removed, execute the following command to
check what programs are using it:
# /opt/hitachi/HNTRLib2/etc/hntr2getname
3-200
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Solaris) User Guide