HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 283)

#
Among the displayed items, HDLM Manager, HDLM Alert Driver, and HDLM
Driver indicate the HDLM component information.
Also, you can view information for each HDLM component. Execute the
dlnkmgr command's view operation with the -sys and subsequent parameter
specified. The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -adrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -pdrv
Starting and Stopping the HDLM Manager
If an error occurs in the system, such as in an HDLM program, you may need
to manually stop or start the HDLM manager to recover from the error.
Starting the HDLM Manager
To start the HDLM manager, log in to Solaris as a user with root permissions
and then execute the following command.
# /etc/init.d/DLMManager start
Lower-case characters can be used for the command name (dlmmanager).
# /etc/init.d/dlmmanager start
The startup script that was set up during HDLM installation runs, and starts
the HDLM manager.
Use the following HDLM command's view operation to confirm that the HDLM
manager is running:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
When the HDLM Manager column shows Alive, the HDLM manager is active.
Stopping the HDLM Manager
To stop the HDLM manager, log in to Solaris as a user with root permissions,
and then execute the following command:
# /etc/init.d/DLMManager stop
Lower-case characters can be used for the command name (dlmmanager).
HDLM Operation
4-15
Hitachi Dynamic Link Manager (for Solaris) User Guide