HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 476)

# reboot -- -r
At the ok prompt, execute the following:
boot -r
• If HDLM devices are used in ZFS or in SVM, do not use the -r option or
the -t option.
Perform the installation without specifying any options.
After the installation has finished, perform the following steps to configure
the HDLM device:
See the procedure outlined in
Changing the Configuration by Restarting
the Host on page 4-37 of Configuration Changes Such as Deleting a
Logical Unit on page 4-36 . Then, stop the use of HDLM devices before
executing the dlmstart utility.
The removehdlm Utility for Removing HDLM
This utility removes HDLM in a Solaris 11 environment.
This utility does not remove HDLM in a Solaris 8, Solaris 9, or Solaris 10
environment. To remove HDLM in such an environment, use the pkgrm
command.
Format
/opt/DynamicLinkManager/bin/removehdlm [-h]
Parameters
-h
Displays the format of the removehdlm utility.
Notes
• Do not use the Ctrl and C keys to interrupt the processing.
• Only use this utility to remove HDLM in a Solaris 11 environment.
• If the KAPL09289-E message is output when you execute this utility,
remove HDLM by using removehdlm, which is stored in the installation
DVD-ROM.
/directory-where-DVD-ROM-is-mounted/HDLM_Solaris/IPS/
remove_scripts/removehdlm[-h]
7-46
Utility Reference
Hitachi Dynamic Link Manager (for Solaris) User Guide