HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 620)

Sun Cluster 3.2 Commands
The table below shows the correspondence between Sun Cluster 3.1
commands and Sun Cluster 3.2 commands used in this manual. For details
about the command options, see the documentation for Sun Cluster 3.2.
#
#
Note that there are no differences between Sun Cluster 3.2 commands
and Oracle Solaris Cluster 3.3 commands.
Table A-1 Correspondence Between Sun Cluster 3.1 Commands and Sun
Cluster 3.2 Commands
Commands for Sun Cluster 3.1 Commands for Sun Cluster 3.2
scconf -a -q globaldev=device-ID-of-the-
Quorum-device
clquorum add device-ID-of-the-
Quorum-device
scconf -c -q installmode cluster set -p
installmode=enabled
scconf -c -q node=node-name,maintstate clquorum disable -t node node-
name
scconf -c -q node=node-name,reset • Change the mode of the node
from the maintenance mode to
the previous mode, and then
reset the quorum vote count.
#1
clquorum enable -t node
node-name
• Reset the quorum vote count #2
clquorum reset
scconf -c -q reset clquorum reset
scconf -pv | grep Quorum clquorum show
scconf -r -q globaldev=device-ID-of-the-
Quorum-device
clquorum remove device-ID-of-the-
Quorum-device
scdidadm -C cldevice clear
scdidadm -L cldevice list -v
scdidadm -l cldevice list -n node-name -v
scdidadm -r cldevice refresh
scdidadm -ui scdidadm -ui
scgdevs cldevice populate
scsetup clsetup
scshutdown -g0 -y cluster shutdown -g0 -y
scstat -q clquorum status
scstat -D cldevicegroup status
A-2
Sun Cluster 3.2 Commands
Hitachi Dynamic Link Manager (for Solaris) User Guide