Section layout, Section layout -90 – JLG 510AJ Service Manual User Manual
Page 132
SECTION 3 - CHASSIS AND TURNTABLE
3-90
– JLG Lift –
3121181
3.14
DGC DIAGNOSTIC SUPPORT AND TROUBLE
CODE DEFINITIONS
This section defines the diagnostics and recommended trou-
bleshooting procedures associated with an EControls Diesel
Governor Control (DGC) engine control module (ECM) for use
on industrial engines.
Section Layout
This section is organized in the following manner:
DTC XXXX- Diagnostic Condition
Block Diagram of Circuit
External Hardware Input/Output- This identifies the hardware that either sends an input
to the ECM or is driven by and ECM output.
Check Condition- This defines what condition to troubleshoot the fault condition.
Fault Condition(s)- This identifies the condition(s) that set the fault.
Corrective Action(s)- This identifies the RECOMMENED corrective action(s) that the
ECM is generally programmed to perform. In some instances, the calibration
engineer(s) may choose to perform a different action.
Emissions or Non-emissions related fault
Text to identify the circuit of interest and its use for control.
Text to describe t he conditions that cause the fault to set.
DTC XXXX- Diagnostic Condition
Note: Helpful tips used to aid troubleshooting
Yes
No
Troubleshooting flow
chart