Disassembly, Disassembly -12 – JLG 510AJ Service Manual User Manual
Page 210
Advertising
SECTION 4 - BOOM AND PLATFORM
4-12
– JLG Lift –
3121181
Disassembly
1.
Remove capscrews (113) over end cap lock pins (109).
2.
Using a 1/8” (3.18mm) drill bit, drill a hole in center of
each lock pin to a depth of approximately 3/16”
(4.76mm).
3.
Remove lock pins using an ”Easy Out” (Size #2 is shown).
If pin will not come out with ”Easy Out”, use 5/1
6” drill
bit to a depth of 1/2” (12.7mm) to drill out entire pin.
4.
Install end cap (4) removal tools provided with Helac
seal kit.
5.
Using a metal bar, or something similar, unscrew end
cap (4) by turning it counter clockwise.
6.
Remove end cap (4) and set aside for later inspection.
Advertising