JLG 510AJ Service Manual - Manual (Page 344)

SECTION 6 - JLG CONTROL SYSTEM
6-62 – JLG Lift – 3121181
hi TILTED - NO/YES Displays status of hi tilt input. (Displayed if external tilt sen-
sor is configured)
AUX POWER OP/CL Displays the status of the auxiliary power switch input
HORN OP/CL Displays the status of the horn input
R FILTER OP/CL Displays the status of the return hydraulic filter by-pass
switch. Displayed ONLY if MODEL = 600 (Configuration
digit = 3)
C FILTER OP/CL Displays measured status of charge pump filter bypass
switch. Displayed ONLY if MODEL = 600 (Configuration
digit = 3)
JIB BLOCK OP/CL Displays jib block limit switch status. Not displayed if asso-
ciated configuration digit = 0
BASKET STOWD YES/NO Displays status of basket stowed mode. (Displayed if
MODEL NUMBER = 7 or 8)
SOFT LIMIT OP/CL Displays status of soft touch limit switch. Not displayed if
associated configuration digit = 0
SOFT O/R OP/CL Displays status of soft touch override switch. Not dis-
played if associated configuration digit = 0
GEN SET/WELDER OP/CL Displays generator/welder switch input status. Not dis-
played if associated configuration digit = 0
LIGHTS OP/CL Displays head and tail light switch input status. Not dis-
played if associated configuration digit = 0
bsk tilt1 XX.X Displays indicated platform tilt angle. Displayed on mod-
els equipped with Electronic Platform Leveling.
bsk tilt2 XX.X Displays indicated platform tilt angle. Displayed on mod-
els equipped with Electronic Platform Leveling.
axle RET sw OP/CL Displays status of axle extension user switches. (Displayed
if MODEL NUMBER = 7 or 8)
axle EXT sw OP/CL Displays status of axle retraction user switches. (Displayed
if MODEL NUMBER = 7 or 8)
axle lim sw RET/EXT Displays status of axle extension limit switches. (Displayed
if MODEL NUMBER = 7 or 8)
dos lim sw OP/CL Displays status of Drive Orientation System Limit Switch.
(Displayed if MODEL NUMBER = 7 or 8)
dos o/r SW OP/CL Displays status of Drive Orientation System Override
switch. (Displayed if MODEL NUMBER = 7 or 8)
CAPACITY SW 500/1000 Displays status of capacity selection switch. (Displayed if
MODEL NUMBER = 7 or 8)
Table 6-8. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1 st Line)
Parameter
(Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description