JLG 510AJ Service Manual - Manual (Page 307)

SECTION 6 - JLG CONTROL SYSTEM
3121181 – JLG Lift – 6-25
19 LOAD TYPE Selects if we are
using the LSS
Module, built in
load cell or the
BPE module (if
selected model
uses the Gorilla
Platform Mod-
ule)
NOTE: Not dis-
played if LOAD: is
0=NO 0=1 ON ROTATOR Use the on-board load sensor for all models
except those models which use the Gorilla Plat-
form Module, which use the BPE module inter-
face for Platform load sensing 0
1=4 UNDER BASKET Use the LSS Module
20 ANGLE: Displays pres-
ence/function of
angle sensor
NOTE: 2=ANA-
LOG Not Dis-
played 1=DIGITAL 1 Limit switches are installed or switches are
not present on this model 1
2=ANALOG 2 An analog sensor is installed
21 LENGTH: Displays pres-
ence/function of
length sensor
NOTE: 2=ANA-
LOG Not Dis-
played 1=DIGITAL Limit switch installed or switches are not present
on this model 1
2=ANALOG 2 An analog sensor is installed
22 FUNCTION
CUTOUT: Displays pres-
ence/function of
drive cutout. 0=NO No Drive Cutout 0
1=BOOM CUTOUT Boom Function Cutout While Driving Above Ele-
vation. (CE)
2=DRIVE CUTOUT Drive Cutout Above Elevation
3=DRIVE CUT E & T Drive Cutout Above Elevation And Tilted
23 GROUND
ALARM: Displays/adjusts
ground alarm
presence/func-
tion 0=NO No Ground Alarm installed 0
1=DRIVE Travel alarm – sounds when the drive function is
active. (Option)
2=LIFT DOWN Descent alarm – sounds when either lift down is
active. (Option)
3=BOOM & DRIVE Motion alarm – sounds when any function is
active. (Option)
24 T PROX
SWITCHES: Displays pres-
ence/function of
Tower Proximity
switches. 0=NO No Tower Prox Switches Installed 0
1=YES Tower Prox Switches Installed
Table 6-1. Machine Set-Up Parameters
Configurati
on
Digit
Parameter
Displayed on
Analyzer
Line 1
Description
Parameter
Value
Definition
Defaul
t
Numb
er