JLG 510AJ Service Manual - Manual (Page 343)

SECTION 6 - JLG CONTROL SYSTEM
3121181 – JLG Lift – 6-61
SYSTEM:
GM BATTERY XX.XV Ground module battery voltage
PM BATTERY XX.XV Platform module battery voltage
AMB. TEMP XXXC Ambient temperature
FSW1 OP/CL Displays footswitch status. NOTE: FSW1 is wired to the
ground module.
FSW2 OP/CL Displays footswitch status. NOTE: FSW2 is wired to the
platform module.
ABOVE ELEV. OP/CL/YES/NO Displays above elevation cutout switch status or above
angle status
LEN SW 1 OP/CL Displays status of boom length retracted limit switch (Dis-
played if MODEL NUMBER = 7 or 8)
LEN SW 2 OP/CL Displays status of boom length retracted limit switch (Dis-
played if MODEL NUMBER = 7 or 8)
RETRACTED YES/NO Displays status of boom length retracted (Displayed if
MODEL NUMBER = 7 or 8)
TRANSPORT YES/NO Displays status of transport position
U LIFT CUTOUT OP/CL Displays status of boom length retracted limit switch (Dis-
played if MODEL NUMBER = 6)
T LIFT PROX OP/CL Displays status of tower lift proximity switch (Displayed if
TOWER PROX SWITCHES = 1)
T TELE PROX OP/CL Displays status of tower telescope proximity switch (Dis-
played if TOWER PROX SWITCHES = 1)
BR CABLE CUT. OP/CL Displays status of broken cable switch (Displayed if BRO-
KEN CABLE SWITCH = 1)
CREEP ACTIVE/NOT ACTIVE Displays pump pot creep switch status. Not displayed if
MODEL = 601 (machine digit = 4)
CRP MODE ACTIVE/NOT ACT Displays creep mode status
SUPER CREEP ON/OFF Displays super creep mode status (Displayed if MODEL
NUMBER = 7 or 8)
TILT XX.X DEG Displays measured vehicle tilt. (Displayed if internal tilt
sensor is configured)
LO TILTED - NO/YES Displays status of lo tilt input. (Displayed if external tilt sen-
sor is configured)
Table 6-8. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1 st Line)
Parameter
(Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description