JLG 510AJ Service Manual - Manual (Page 79)

SECTION 3 - CHASSIS AND TURNTABLE
3121181 – JLG Lift – 3-37
3. Place thrust washer (11) around spindle (1A) so it rests
on bottom of internal gear (2).
4. Stand input shaft (7A) on its splined end. Place one
spacer (7D) on smooth end of input shaft (7A).
5. Place one spring (7C) on smooth end of input shaft (7A).
6. Place spacer (7D) on smooth end of input shaft (7A).
WEAR SAFETY GLASSES DURING THIS STEP, AND BE AWARE THAT SPRING AND
SPACERS, COMPRESSED BY RETAINING RING, MAY POP SUDDENLY OFF SHAFT IF
THE RING IS RELEASED BEFORE IT IS PROPERLY IN PLACE.
7. Using retaining ring pliers, insert retaining ring (7B) in
groove on input shaft (7A) by compressing spring and
spacers together.
8. With large splined end down, place input shaft sub-
assembly (7) in spindle (1A).