JLG 510AJ Service Manual - Manual (Page 75)

SECTION 3 - CHASSIS AND TURNTABLE
3121181 – JLG Lift – 3-33
Cover Sub-Assembly
1. Using the disconnect rod, push O-ring (6F) in groove
inside cover cap (6B).
2. Place O-ring (6G) on cover cap (6B) so that it rests
against flange of cover cap.
3. Insert disconnect rod (6E) in cover cap (6B).
4. Set cover (6A) on table, exterior side up. Place cover cap
(6B) on cover (6A), aligning pipe plug hole in cover cap
over pipe plug hole in cover.
5. Place two cover cap bolts (6C) in any two bolt hoes that
are 180° apart on cover cap (6B) and tighten bolts.
6. Using a torque wrench, apply 36 to 49 in-lb (4 to 5 Nm)
of torque to both bolts (6C).