JLG 510AJ Service Manual - Manual (Page 47)

SECTION 3 - CHASSIS AND TURNTABLE
3121181 – JLG Lift – 3-5
Input Carrier Disassembly
1. Place Carrier (3A) on a press with spline end up. Drive
Planet Shaft (3E) out of Carrier (3A).
2. Slide Planet Gear (3F) and two Thrust Washers (3B) out
of Carrier (3A).
3. Remove 14 needle Bearings (3C) from bore of Planet
Gear (3F).
4. Repeat steps 1 through 3 for two remaining planet
gears.
3A. Carrier 3E. Planet Shaft
3B. Thrust Washers 3F. Planet Gear
3C. Needle Bearings
Figure 3-3. Input Carrier Disassembly