JLG 510AJ Service Manual - Manual (Page 314)

SECTION 6 - JLG CONTROL SYSTEM
6-32 – JLG Lift – 3121181
GEN SET CUTOUT:
12*
* Only visible if Gen Set /
Welder Menu selection is
not 0.
0
1
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only.
0
H & T LIGHTS:
13 0
1
NO: No head and tail lights installed.
YES: Head and tail lights installed.
0
CABLE SWITCH:
14*
*
Only visible under cer-
tain model selections.
* Certain market and
model selections will alter
the default setting.
0
1
NO: No broken cable switch installed.
YES: Broken cable switch installed.
0
LOAD SYSTEM:
15*
* Only visible under certain
model selections.
* Certain market selections
will limit load system
options or alter default set-
ting.
0
1
2
3
4
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm
beeps (5 sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS
off ), platform alarm beeps (5 sec ON, 2 sec OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out
& main lift up, platform alarm beeps (5 sec ON, 2 sec OFF).
0
LOAD SENSOR:
16*
* Only visible if Load Sen-
sor Menu selection is not 0.
* Market selections will
limit certain load sensor
options.
0
1
1 ON ROTATOR: Use the on-board load sensor for all models except those
which use the Leveling Platform Module.
4 UNDER PLATFORM: Use the EIM for load sensing.
1
FUNCTION CUTOUT:
17*
* Only visible under cer-
tain market selections.
* Certain market selec-
tions will limit function
cutout options or alter
default setting.
0
1
2
3
NO: No drive cutout.
BOOM CUTOUT: Boom function cutout while driving above elevation.
DRIVE CUTOUT: Drive cutout above elevation.
DRIVE CUT E&T: Drive cutout above elevation and tilted.
0
Table 6-3. Machine Configuration Programming Information Prior to Software Version P5.3
Configuration Digit
Numb
er
Description
Default
Number