RKI Instruments Gas Tracer - Manual (Page 125)

Gas Tracer Operator’s Manual Leak Testing • 117
The gas readings that were taken during the snap log are displayed
and the Station ID that was in use during the snap log is displayed
along the bottom of the screen. Snap log data that was taken in
Leak Check Mode operation will have 2 sequential screens that are
part of one data set. One screen is for the base reading and the
other screen is for the peak reading. The peak reading value will
have PEAK displayed below the peak bar. If a base data point
appears without a peak data point after it, it is because a peak data
point was not taken. You can use the AIR▲ and (SHIFT)▼
buttons
to scroll through the different snap logs. The gas readings and
station ID will change but the snap log ID is not visible from this
screen.
6. To exit snap log data viewing and return to Leak Check Mode
Operation, press and release the DISPLAY (ADJ) button.
Turning Off the Gas Tracer, Leak Check Mode
1. Press and hold the POWER ENTER button.
2. The buzzer will pulse for about three seconds and TURN OFF will
appear at the bottom of the screen.
3. Release the button when TURN OFF disappears.