RKI Instruments Gas Tracer - Manual (Page 63)

Gas Tracer Operator’s Manual Display Mode • 55
Uppercase letters, numbers, asterisks (*), dashes (-), and a blank space
are available characters. The Gas Tracer can store 128 station IDs.
Use this screen to identify or change the station. The station ID
provides a way to identify the station during a data logging session.
The station ID is saved to the data logger for that session when you
turn off the Gas Tracer or change stations during operation. This
allows you to change the station ID during operation and have each
station ID that was used during an operating session saved for the
corresponding data.
NOTE: As shipped from the factory, the station ID on this screen is
shown as -- -- -- -- -- -- until you enter this screen and select a
station ID.
To change a station:
1. After entering Display Mode and proceeding to the Station ID
screen, press and hold the POWER ENTER button. The bottom line
of this screen alternates between YES/ENT., the current user ID,
and NO /DISP.
2. Use the AIR▲ and (SHIFT)▼ buttons to scroll through the 128
possible station IDs.
3. Press the POWER ENTER button to select a station ID.
S Id
YES/ENT.
SEL
S Id
001
SEL