RKI Instruments Gas Tracer - Manual (Page 67)

Gas Tracer Operator’s Manual Display Mode • 59
The gas readings that were taken during the snap log are displayed
and the Station ID that was in use during the snap log is displayed
along the bottom of the screen. Snap log data that was taken in
Leak Check Mode operation will have 2 sequential screens that are
part of one data set. One screen is for the base reading and the
other screen is for the peak reading. The peak reading value will
have PEAK displayed below the peak bar. If a base data point
appears without a peak data point after it, it is because a peak data
point was not taken. You can use the AIR▲ and (SHIFT)▼
buttons
to scroll through the different snap logs. The gas readings and
station ID will change but the snap log ID is not visible from this
screen.
Peak Bar Select Screen
The Peak Bar Select Screen allows you to turn the peak bar on or off. If
the function is turned on, the peak bar appears along the left side of
the screen during Normal Operation and on the Peak Screen in
Display Mode. It shows the peak readings for each channel in bar
graph format. The bottom line of this screen alternates between the
current setting, NO /DISP, and YES/ENT.
To adjust the peak bar selection:
1. Use the DISPLAY (ADJ) button to scroll to the Peak Bar Select
Screen. The screen indicates the current setting.
bAr
SEL
BAR OFF
bAr
SEL
BAR ON