Snap log mode, normal operation – RKI Instruments Gas Tracer User Manual
Page 43
Gas Tracer Operator’s Manual
Measuring Mode, Normal Operation • 35
Snap Log Mode, Normal Operation
NOTE:
For instructions to take snap log data if using the Gas Tracer
in Leak Check Mode, see “Snap Log Mode, Leak Check Mode
Operation” on page 112.
The snap logging function in Snap Log Mode allows the user to record
data at a specific time and have it saved to the data logger. The data is
assigned a snap log ID and is saved with the station ID that was in use
when the data was taken.
To enter Snap Log Mode and record snap log data:
1. Turn the Gas Tracer on as described in “Turning On the Gas Tracer,
Normal Mode Only” on page 20. Press and hold the (SHIFT)T
button, then press and hold the AIRS button and hold both until
you hear a beep. The unit will cycle through the following screens.