RKI Instruments Gas Tracer - Manual (Page 62)

54 • Display Mode Gas Tracer Operator’s Manual
saved to the data logger for that session when you turn off the
Gas Tracer or change users during operation. This allows you to
change the user ID during operation and have each user ID that was
used during an operating session saved for the corresponding data.
NOTE: As shipped from the factory, the user ID on this screen is
shown as -- -- -- -- -- -- until you enter this screen and select a
user ID.
To change a user:
1. After entering Display Mode and proceeding to the User ID screen,
press and release the POWER ENTER button. The bottom line of
this screen alternates between YES/ENT, the current user ID, and
NO /DISP.
2. Use the AIR▲ and (SHIFT)▼ buttons to scroll through the 128
possible user IDs.
3. Press the POWER ENTER button to select a user ID.
Station ID Screen
This screen displays only if ID DISP in the Maintenance Mode menu
is set to ON (see “Turning the ID Display Function On or Off” on
page 167). Each station ID can contain up to 16 characters but only the
first 8 of those characters are visible in the instrument. Be sure that all
station IDs are distinguishable from each other by viewing only the
first 8 characters. For more information, see the GX-2012 Data Logger
Management Program manual. The bottom line of the screen
alternates between YES/ENT., the current station ID, and NO /DISP.
U Id
YES/ENT.
SEL
U Id
USER--001
SEL