Rockwell Automation 20M LPM15 Liquid-Cooled Adjustable Frequency AC Drive FRN 2.xxx - Manual (Page 145)

Index-9
reference control, 1-28
Reference Mask parameter, 3-25
Reference Owner parameter, 3-26
repeated start/stop, 1-24
Replaced MCB-PB fault, 4-5
replacement parts, 4-16
Reset Meters parameter, 3-20
Reset To Defaults parameter, 3-19
Reset to Defaults, HIM, C-4
Restart Modes Parameter Group, 3-16
Reverse Speed Limit, D-8
Run Boost parameter, 3-9
S
S Curve % parameter, 3-15
S.M.A.R.T. start up, 2-3
Save HIM Ref parameter, 3-19
Save MOP Ref parameter, 3-19
Save To User Set parameter, 3-19
saving data, C-4
setting preferences, C-4
Shear Pin fault, 4-5
short circuit protection, 1-13
signal wire, 1-25
Skip Freq Band parameter, 3-10
Skip Frequency, D-9
Skip Frequency x parameter, 3-10
Sleep Config alarm, 4-7
Sleep Level parameter, 3-17
Sleep Time parameter, 3-17
Sleep Wake Mode, D-10
Sleep-Wake Mode parameter, 3-17
Sleep-Wake Ref parameter, 3-17
Slip Comp Gain parameter, 3-12
Slip Comp Parameter Group, 3-12
Slip RPM @ FLA parameter, 3-12
Slip RPM Meter parameter, 3-12
Software fault, 4-5
specifications
agency certification, A-1
control, A-2
electrical, A-2
environment, A-1
protection, A-1
Speed Command File, 3-10
speed command sources, 1-28
Speed Mode parameter, 3-10
speed pot, 1-27
Speed Ref A Hi parameter, 3-11
Speed Ref A Lo parameter, 3-11
Speed Ref A Sel parameter, 3-11
Speed Ref B Hi parameter, 3-11
Speed Ref B Lo parameter, 3-11
Speed Ref B Sel parameter, 3-11
Speed Ref Cflct alarm, 4-7
Speed Ref Source parameter, 3-21
Speed Reference
control, 1-28
selection, 1-29
Speed References Parameter Group, 3-11
Speed Trim Parameter Group, 3-12
standard control, I/O terminal block, 1-26
Start At PowerUp alarm, 4-7
Start At PowerUp parameter, 3-16
Start Inhibits parameter, 3-21
Start Mask parameter, 3-25
Start Owner parameter, 3-26
Start/Acc Boost parameter, 3-9
start/stop, repeated, 1-24
start-up
assisted, 2-3
checklist, 2-1
S.M.A.R.T., 2-3
static discharge, ESD, P-2
Status 1 @ Fault parameter, 3-22
Status 2 @ Fault parameter, 3-22
status indicator, 2-2, 4-2
Stop Mode x parameter, 3-15
Stop Owner parameter, 3-26
Stop/Brake Modes Parameter Group, 3-15
SV Boost Filter parameter, 3-8
SW OverCurrent fault, 4-5
system grounding, 1-15
T
TB Man Ref Hi parameter, 3-11
TB Man Ref Lo parameter, 3-11
TB Man Ref Sel parameter, 3-11